[. . . ] If you have any questions or need assistance, please contact TecmaServiceat1-800-543-1219. [. . . ] Note: Use only marine-quality reinforced hoses during EasyFit installation. Make sure hoses are not kinked and wiring is nottrappedbetweenthechinaandthewallor floor. Smooth the excess silicon bead around the perimeter of toilet, adding more silicon around the perimeter if neededtocreateauniformseal. (Note: Wires can point in any direction ­ the sensors directional orientationdoesnotaffectitsoperation. The Full Tank Sensor is mounted at the highest point on the tank for the tank's capacity, or where the installer wants the Tank Full indication to be. The area for adhesion should be thoroughly cleaned with alcohol or equivalent, and dried, prior to mounting the sensor Les endroits où les capteurs adhèrent au réservoir doivent être entièrement nettoyés avec de l'alcool ou son équivalent et séchés avant l'installation des capteurs. Apply dielectric grease to wire terminals before terminals are installed in housings. Keep out of reach of children Do not wire pump directly to a power source so that it is controlled by its pressure-activated switch. [. . . ] Must be 16 gauge, not provided with toilet, connector information is available in this manual. [. . . ]